I turned on my profex II yesterday and all that occurs is a message saying "parameters exceeded, auto correcting". It keeps saying this. What is going on? I don't have a card to reload the presets. Are the presets gone for good?
------------------
Steve Stallings
Bremond, Texas
Profex II Problem
Moderator: Dave Mudgett
-
Steve Stallings
- Posts: 2757
- Joined: 9 Sep 1998 12:01 am
- Location: Houston/Cypress, Texas
-
Bill Terry
- Posts: 2810
- Joined: 29 Apr 1999 12:01 am
- Location: Bastrop, TX
I found this link with a 'directory' of factory reset sequences for a variety of stuff. According to this, hold Play and Global keys while powering up.
A while back my Profex (original) was doing the same thing. I think it got scrambled during an on-stage power outage. When you scrolled through the patches, some of them had garbage characters and I got that same error message periodically. The factory patch reset sequence fixed it.
http://www.cadvision.com/Home_Pages/accounts/ranaud/presets.htm
This restores the factory presets, anything you've modified is gone.
------------------
Home Page
<FONT SIZE=1 COLOR="#8e236b"><p align=CENTER>[This message was edited by Bill Terry on 18 June 2002 at 12:31 PM.]</p></FONT>
A while back my Profex (original) was doing the same thing. I think it got scrambled during an on-stage power outage. When you scrolled through the patches, some of them had garbage characters and I got that same error message periodically. The factory patch reset sequence fixed it.
http://www.cadvision.com/Home_Pages/accounts/ranaud/presets.htm
This restores the factory presets, anything you've modified is gone.
------------------
Home Page
<FONT SIZE=1 COLOR="#8e236b"><p align=CENTER>[This message was edited by Bill Terry on 18 June 2002 at 12:31 PM.]</p></FONT>